Description
Warm Audio WA-RA – Reamper
The Warm Audio WA-RA Reamper is a routing hub that connects guitar amps, pedals, synthesizers and studio equipment, whilst also enabling tube amps to be recorded without noise.
With the Reamper, dry DAW signalsfor example, from an audio interfacecan be routed directly through any tube amp. Integrating studio equipment into the guitar signal chain or guitar effects into the studio signal chain is also easily achievable with the WA-RA. Thanks to the integrated power soak, tube amps with up to 50 W (8impedance) can also be recorded silently without a speaker.
The WA-RA is not limited to guitars. Any synth modules can also be added as line-level sources.
- Two-channel active instrument preamp and re-amp
- Independent signal paths for instrument preamp and re-amping
- Bespoke CineMag USA transformers in each signal path (inputs and outputs)
- Connect instrument, line-level and speaker-level signals
- Compatible with passive and active instruments, keyboards and pedals
- Speaker input with direct-through or integrated power soak for silent operation
- Continuously variable re-amp output level control for attenuation or gain
- Balanced line-level inputs and outputs via XLR and 6.3 mm connectors (no phantom power required)
- Switchable instrument input stage: discrete JFETs or JFET operational amplifiers
- Fully active circuitry with extremely low-noise design
- High-quality components throughout the signal path
- Internal universal power supply
- Maximum instrument input level: +18 dBu (6 VRMS)
- Instrument input impedance: variable from 120 k to 1 M
- Re-Amp output level: continuously variable control from attenuation to gain
- Speaker power soak: 8 ohms, max. 50 watts
- Balanced line output: True line level on XLR and 6.35 mm
- Phase reversal and ground lift per channel
- Power supply: 90240 V AC, 5060 Hz
- Dimensions: 29.7 x 16.2 x 10.7 cm
- Weight: 1.65 kg
